Products 1-19 of 19
Item #: AHU1856 -
The same large bearing is used to support the differential in all Mini models. Occasionally sealed bearings are supplied due to availability, but the seal should be removed before installation. Aftermarket.
11/8/2017 12:00:00 AM
Item #: AHU1856-RHP -
Racers and other top-end customers often ask for OEM UK-made RHP brand diff bearings for longest life and proven reliability. Full width.
11/8/2017 12:00:00 AM
Item #: AHU1707 -
In 1979, the improvements to the gearbox included enlarging the too-small idler gear pin to .875" diameter and using stronger bearings to support it. These 1.375" OD bearings are found
Item #: 13H7848 -
This 1.065" OD bearing supports the .75" pin of the idler gear on 4-synchro trannies up to 1979. Found in both the gearbox casing and flywheel housing, but please verify
Item #: 88G0302 -
The upper arm uses two of these bearings. Worn oil seals can allow them to be damaged from road grit. Available individually or included in SSS0008 upper suspension arm repair
6/5/2019 12:00:00 AM
Item #: C-AJJ3385 -
This heavy-duty differential is recommended for any high performance road Mini or Mini Cooper. A standard Mini differential has only one pin and one pair of spider gears. This improved
Item #: CHM0085 -
Differential side cover with bushing installed. Fits Minis 1959-73, but can also be used on left side of rod-change transmission with yoke outputs or pot joint.
Item #: CHM0085-USED -
Used differential side cover with bushing installed. Fits Minis 1959-73, but can also be used on left side of rod-change transmission (does not have the required lug for right side of rod change).
5/7/2019 12:00:00 AM
Item #: DAM6027-USED -
Used, A+ differential cage, which utilizes the improved DAM5071 spider gear thrust washers.
Item #: DAM3108 -
Used for shimming the differential bearings to achieve proper preload.
Item #: DAM3109 -
Used to shim differential bearings for proper preload.
Item #: DAM3633 -
Used to shim the diff to obtain proper bearing preload; thickness .020".
Item #: 2A3506 -
Thin paper gasket between the gear case and the diff housing. Lower section only. Fits pre-rod change models. For rod change, use 22G1836B.
Item #: 2A3505 -
Thin paper gasket between the gear case and the diff housing. Upper section only. Fits all.
Item #: 22A1611 -
This is an aftermarket version of the diff side cover gasket. See TRK10004B for improved gasket.
Item #: 22G1836 -
Thin paper gasket between the gear case and the diff housing. Lower section, fits rod change only. Shown next to the same part for the pre-rod change gearbox
Item #: TRK10004B -
This latest version of the side cover gasket comes with built-in sealant attached to the paper.
11/15/2018 12:00:00 AM
Item #: MSSK050 -
More appropriately referred to as an "Anti Oil Leak Kit", this handy kit updates early Rod Change boxes to the later design, while replacing common problem area seals.
11/11/2017 12:00:00 AM
Item #: ADU5738 -
These seals are from the OE manufacturer, in a compliant rubber with oil scroll. Also called diff side cover seals, this application leaks over time and requires replacement on occasion.