Classic Mini DIY: Early 998 #6 - Painting time!

Very good quality engine enamel in the original ''Mowog Green'' or ''MGA / MGB Burgundy'' colors.

Heavy paper gasket that forms the seal between the flywheel housing and the engine/transmission.

.134''-.135'' thick thrust washer for A-Series idler gear with .75'' pin diameter.

136''-.137'' thick thrust washer for A-series idler gear with .75'' pin diameter.

.138"-.139" thick thrust washer for A-Series idler gear with .75" pin diameter.

Machined steel thrust washer for early idler gear with .75'' pin diameter. Thickness 0.130"-0.131''.

Machined steel thrust washer for early idler gear with .75" pin diameter. 0.132"-0.133" thick.

Machined thrust washer for 1979-on idler gear with .875'' pin diameter. Nominal .134'' thickness.

Machined thrust washer for 1979-on idler gear with .875'' shaft diameter; .136''-.137'' thick. Sold each.

Shim for 1979-on idler gear with .875'' pin diameter. Approximately .138'' thick.

Machined thrust washer for 1979-on idler gear with .875" pin diameter.

No longer available new. Good used condition. Part may show some wear. The three synchro idler gear can also be used on 4-synchro with careful spacing of the

Idler gear for the pre-A+ classic Mini 4-synchro transmission. 31 teeth, .75'' shaft diameter. Reproduction.

Idler gear for A+ transmissions, 1979-on. Tooth count is 37, shaft diameter is .875"

Straight-cut idler gear with .875" shaft for A+ transmission and flywheel housing. Fits Mini Spares' Evolution straight-cut drop gears. 30 teeth.

For use on small engine covers, case halves, and clutch housings; forms a tough flexible bond that is highly effective on irregular and uneven joint surfaces

Permatex Ultra Grey RTV Gasket Maker. Seven recommended gasket-in-a-tube. 3.5 ounce size.