Classic Mini DIY: Rebuilding a Classic Mini Gearbox #4

Large bearing that carries the first motion shaft in the classic Mini gear case starting in 1968-on

Large bearing that carries the first motion shaft in the gear case starting in 1968-on; made by RHP

Two of these are needed in 4 synchro laygears before 1979, and only one for later A+ gears. Fits first motion end of laygear. Sold each.

Starting in 1979, the layshaft was revised and a new needle roller bearing was fitted at the first gear end. This bearing is also used on the end of the

The AAU1365 double row ball bearing supports the mainshaft in the center web of the gearbox. We stock the correct bearing with full-width outer race for best reliability.

Double-row ball bearing supports the mainshaft in the center web of the gearbox. We stock the correct bearing with full-width outer race for best reliability. Manufactured in Germany by RHP.

Improved pipe that moves the oil pick-up point towards the center of the engine

Circlip, or stop ring, around the AAU1365 double ball bearing on the mainshaft.

An improved version of the 3-step A+ layshaft, using a superior material and tougher hardening. Recommend for all applications except full race

Shim, mainshaft double-row bearing retainer, .005". For 4-synchro gearbox.