Products 1-48 of 105
10/4/2019 12:00:00 AM
Item #: VK105 -
Replacement cap for 4-cylinder 123 Distributor. Keep a spare on hand.
Item #: SEL0003 -
All new, fully electronic billet distributor for A-Series engines. Programmed with 16 advance curves to choose from. Dwell is microprocessor controlled, depending on coil current. Works with any standard
Special Order - Call for Details
Item #: SEL0004 -
All new, fully electronic billet distributor for A-Series engines. Programmed with 16 advance curves to choose from. Dwell is microprocessor controlled, depending on coil current. Works with any standard or
Item #: SEL0057 -
Battery cut-off switch. FIA approved. Most race sanctioning bodies require the use of this special (diode protection device) cut out allowing the switching off whilst the engine is running without damaging the electrics.
Item #: TAM1706 -
This bolt is used to secure the forked distributor retainer found on A+ engines to 1985. Later bolt TAM1706 can be used for this application as well.
Item #: 8B12397 -
A little flash for your engine bay! A nice stainless coil bracket to replace that dull original one. Easy and inexpensive, an ideal gift item.
Item #: PER10002 -
Mounting bracket for Pertronix coils. Bright chrome finish. This bracket is not included with the coil, sold separately.
12/12/2019 12:00:00 AM
Item #: PER10001 -
Mounting bracket for Pertronix coils, in zinc. This bracket is not included with the coil (sold separately).
Item #: NSC100760 -
Plastic-bodied cam timing sensor for engine management of MPI Minis. Fits in mechanical fuel pump hole in the block. Genuine Lucas product.
Item #: 12G2994-USED -
Restored A+ coil bracket that mounts on cylinder head stud.
6/11/2018 12:00:00 AM
Item #: GCL0204 -
Ignition coil pack for MPi Mini.
Item #: DLB198 -
High-output Sports Coil for 1984-1996 classic Minis.
Item #: 40001 -
Chrome PerTronix Flame-Thrower ignition coil for Minis with a ballast resistor in the ignition wiring, typically 1984 to 1996.
Item #: 40611 -
This black 40,000 volt Flame-Thrower ignition coil is a perfect complement to the Pertronix inductive Hall Effect distributor module.
Item #: 40501 -
This chrome 40,000 volt Flame-Thrower ignition coil is a perfect complement to the PerTronix inductive Hall Effect distributor module.
Item #: 40011 -
Black PerTronix Flame-Thrower ignition coil for Minis with ballasted ignition system, typically 1984 to 1996 range.
Item #: 40511 -
Oil filled for better cooling and voltage insulation. 3 ohm resistance as used on Minis up to 1984 without an external ballast resistor in the ignition wiring.
Item #: DCB101C -
Condensor to fit 25D distributors, found in Minis up to 1974
Item #: DCB104 -
Condensor, fits every Lucas distributor 1974-on.
Item #: DCB203 -
Some A+ engines were fitted with Ducellier distributors, which required special ignition parts, such as this condenser. See also DDB221 cap, DSB218 points, and DRB229 rotor.
Special Order - Call for Details
Item #: PER600 -
Cheap insurance against scattering your engine! The PerTronix Rev limiter will work on any classic Mini with either points or PerTronix Ignitor electronic ignition, with negative ground only. Its small
6/14/2019 12:00:00 AM
Item #: 54412436 -
Long-pin base plate for mechanical advance 23D and 25D distributors. Uses DSB109 points.
Item #: CLIPS -
Distributor cap retaining clip for 1974-on 45D series distributors. Fits DDB108/GDC136 caps.
Item #: DDB108 -
Top-exit distributor cap for Lucas 45D distributor, 1974 to 1990.
11/16/2017 12:00:00 AM
Item #: DDB101 -
Distributor cap for 23D and 25D pre-A+ distributor, with side-exit terminals. Wires (not included) are held in with screws.
Item #: DDB106 -
Distributor cap for 23D and 25D distributor. Top exit. Formerly sku #GDC103.
6/7/2017 12:00:00 AM
Item #: DDB221 -
Distributor cap for Ducellier A+ distributor. Top exit. Original caps were red, but replacements will be either red or black, depending on supplier availability. This cap is usually
12/18/2018 12:00:00 AM
Item #: GDC156 -
Distributor cap for any electronic distributor. Cap is held on with screws.
Item #: DDB194 -
Non-standard side-exit push-in cap for Lucas 45D distributors. This cap is used when improved weather protection of the distributor is required, or confined space requires the side exit cap.
Item #: 8G0726 -
Rubber waterproofing boot for the early, side exit distributor cap as used on 25D distributors found on the Mini from 1959 through 1973. Because they have no individual boots, these
Item #: 12G3560 -
With the introduction of the improved A+ engines from Rover, one of the the changes was a revised distributor and it mounting system and drive gear. The drive gear has a wider slot for the larger engagement dog on the bottom of the distributor.
Item #: 12G3560-USED -
Used. With the introduction of the improved A+ engines from Rover, one of the the changes was a revised distributor and it mounting system and drive gear. The drive gear has a wider slot for the larger engagement dog on the bottom of the distributor.
Item #: 12G4499-USED -
Good condition used distributor drive spindle/gear for A-series only. They get damaged or lost when engines are taken apart, so we keep a good stock on hand.
Item #: TAM1671 -
This is the later A+ distributor retainer, introduced with the “black box” electronic distributor. If you are using the factory electronic distributor, this is the only clamp that will allow it to fit the block in the correct orientation. Sold each.
Item #: 613857A -
A+ distributor retaining clamp. to be used with points-type distributor or aftermarket electronic distributor.
5/17/2017 12:00:00 AM
Item #: 3H2138 -
Replacement clamp for all distributors used on A-series (not A+) engines.
Item #: FOR049 -
A nice stainless steel hold-down clamp for points-type A+ distributor, with graduated markings for advance calibration. Laser cut from stainless steel. Not suitable for black-box electronic distributor models.
11/9/2017 12:00:00 AM
Item #: ADU3825 -
59D points-type distributor for 1275 A+ engine, including Metro. Complete assembly including cap, rotor, points and condenser.
4/9/2019 12:00:00 AM
Item #: 12G2140 -
23D mechanical advance A-Series distributor, with the looks of a Cooper S distributor but fitted a top-exit cap.
Item #: SEL0165 -
This A-Series distributor has the looks of a Cooper S distributor, but with the convenience of electronic ignition.
Item #: 25DE -
A brand-new distributor with the looks of the Lucas 25D distributor, but with maintenance-free electronic ignition.
Item #: 45D4E -
Modern Japanese electronics have been combined with the Lucas 45D4 Distributor to give you the best of both worlds, maintenance-free ignition with the original look of your British Distributor.
Item #: ADU5789 -
59D points-type distributor for A+ 998cc, 1981-1989.
Item #: SEVU023 -
Used Lucas 59D series points distributor for A+ blocks. With vacuum advance unit. Cap, points, rotor and condenser may not be included and should be ordered new at time of purchase.
Item #: C-27H7701 -
A+ electronic ignition distributor with vacuum advance, curved to give best performance on Minis with performance camshaft up to to 276 spec.
Item #: SEL0109 -
Race or high performance distributor for classic Mini A-plus engines; points can be either red- or blue-type
Item #: SEL0047 -
Aldon Red distributor for race-tuned engines. Fits pre-A+ engines only; mechanical advance only in this unit.
8/16/2018 12:00:00 AM
Special Order - Call for Details
Item #: SEL0108 -
Aldon Yellow non-vacuum advance distributor for A-Plus for performance street application.