HIF4-38 1.5"

.090 floating needle for HS2, HS4 or HIF4 S.U. carburetor; AAB.

AAR spring-loaded or swing needle for SU HS2, HS4, or HIF4 carb.

.090 Floating Needle for HS2, HS4 or HIF4 SU Carb. Spring-loaded equivalent of the M needle.

SU carb needle, biased type. ABY code.

OEM SU Service Kit for minor rebuild of 1.5" HIF4/HIF38. Kit includes correct .090" jet, gaskets, seals and fuel level needle/seat. Many of these carbs are now used on 1000cc

Fiber washer used under the damper cap on SU HS carburetors

Square section O-ring type float chamber seal for all HIF SU carburetors.

New float lid base for the bottom HIF38, HIF44 and HIF6 carbs.

Gasket between carb and air cleaner allow elbow.

Small metal guide that retains the spring-loaded or "swinging" needle on SU HS or HIF carburetors

Stainless heat shield/linkage plate for HIF carburetors. The OEM plate CAM4942 for HIF6/44 is no longer available. Will never rust.

Pivot pin for float in HIF carbs. Includes washer.

Needle Set Screw, sliding chamber

Very small spring that fits on the "top hat" of the spring-loaded carb needle

A very handy kit of special screws, springs, and pivot pin. Invaluable if you have misplaced any of these.

Cam-type throttle lever for the HIF Carburetor. As supplied on SIE0038.

Replacement throttle shaft kit for 1-1/2? SU HIF38 or HIF4. Includes shaft, seals, butterfly screws and gasket.

Fits around the stem of the damper to prevent the damper from dropping out of the dashpot cover. Fits SU HIF carburetors.