Products 1-16 of 16
Item #: 27H4776-USED -
Left-hand side replacement for original pre-pot joint drive shaft. These are identical to the stock shaft, including the stop ring groove.
Item #: 27H4775-USED -
Right-hand side replacement for original pre-pot joint drive shaft. These are identical to the stock shaft, including the stop ring groove.
Item #: CWP3.2-USED -
Matched pair of 3.1 final drive gears; tooth count 19/61. Used.
Item #: SBO0251 -
Metal plate with round pass-thru hole that bolts to the inner side of the firewall, and covers the large hole. This was used 1984-on, on classic Minis with driver’s-side binnacle.
Item #: 22G1858-USED -
This is the gear selector rod that protrudes through the oil seal at the rear of all rod change gearboxes. Used.
Item #: 47H5086-USED -
Used, reproduction Austin logo horn push button for the center of the Mk1 and Mk2 Mini horn push assembly.
Item #: 12A2153-USED -
Lower radiator mounting bracket that bolts on top of the engine front bracket; refurbished.
Item #: SEVU0056-REB -
22A250 Mini Cooper-type remote shift assembly, as used beginning in 1964. Includes chrome shift lever and all associated parts. Thoroughly cleaned, inspected, lubricated, and small parts replaced as necessary.
Item #: 22G290-USED -
Circular metal retainer for remote shift gear levers, for remote-shift Minis from 1964-1973. Used, condition may vary.
Item #: DAM6240-USED -
Used second gear for late SPi Mini, usually from France, with 25 tooth 2nd gear.
Item #: 21A1515-USED -
Used-condition protective nylon sleeve to prevent chafe of the hydrolastic displacer hose. A total of four (4) were fittted to front and rear of "wet" Minis.
Item #: 88G0228-USED -
Metal spacer used between the remote shift extension and the sheet metal cup at the pivot ball of the shift lever. Used, condition may vary.
Item #: 22G286-USED -
1-1/2” diameter coil spring that fits on top of the ball on remote shift lever, 1964-on. Used condition.
Item #: 21A2463-USED -
Under-dash steering column bracket. Bolts to underside of lower dash rail; as used on cars fitted with locking ignition switch but can be fitted to earlier Minis too.
Item #: JPC2839-USED -
Used switch mounting panel that accepts four of the smaller rocker switches as used from about 1976-on. Actual condition may vary from shown.
Item #: 12G1811-USED -
This wing nut has a long sleeve and is normally used with Mini 1000 or Austin America air filter housings. No longer available new so we keep used ones on hand.