Products 145-192 of 544
Item #: SEL0045MG -
A 52mm combined Fahrenheit mechanical water temperature gauge and 0-100 PSI oil pressure gauge, with Smiths name on magnolia face with original chrome v-profile bezel. Note that few Smiths temp
Item #: CWB324 -
Electrical Crimp Bullet, 3mm
Item #: CWB121 -
Electrical Female Terminal, 1/4" Lucar Connector
Item #: CWB123 -
Electrical Female Terminal, 1/4", Large
Item #: CWB122 -
Electrical Female Terminal, 1/4", Small
Item #: CWB130 -
Electrical Female Terminal, 3/8", Lucas
Item #: CWB420 -
Electrical Sleeve, Transparent, 1/4" Lucar
Item #: CWB320 -
Electrical Solder Bullet, 3mm
2/14/2019 12:00:00 AM
Item #: SCO0094 -
Steel face plate for fresh air heaters with the vertical slide control. Painted wrinkle-finish black, and stenciled with “car” “screen” and “off”, as original.
Item #: GCB10813 -
Fan belt for use with standard, small water pump pulley and alternator. Made in England.
Item #: GCB10825 -
Fan belt for use with standard small water pump pulley and alternator or generator with small pulley. Made in England.
Item #: YWL10010 -
Late Mini temperature sending unit. This unit screws into the thermostat housing "sandwich" plate. Fits Cooper to 92, Metric 8mm thread. Wiring harness. Genuine Rover.
Item #: 740811 -
Threaded ferrule that fits into the end of the wiper motor, and hold the tube and wheel box assembly to the wiper motor; the correct part for the round-body 2-speed wiper.
Item #: 2K4936 -
Fiber washer for use on oil pressure capillary tube from engine block to gauge. Outside diameter .351".
8/23/2017 12:00:00 AM
Item #: GFU2208 -
Three-prong flasher unit that operates both turn signals and hazard light on 1991 and later Minis. Mounted to speedometer cluster brackets behind dash.
Item #: S6078 -
See and be seen with Wipac fog lights. They project a wide beam to light up the sides of the road. Sold as a pair. Chrome, all metal body,
Item #: MSA1115 -
Small bracket-mounted red lamp as required by European laws to prevent rear end collisions.
8/31/2017 12:00:00 AM
Item #: AFU3389 -
A different front turn signal was used from 1987-on. The lamp is single function, and bulb 382 is not included. The lens is plastic, and held on by two
8/31/2017 12:00:00 AM
Item #: AFU3389W -
Late model front single function turn signal lamp assembly with stylish clear plastic lens. Lens is held on with two screws. Bulb (382) not included.
Item #: 1B9100MS -
Budget plastic version of beehive front USA-spec dual function turn indicator lamp. Install with three (3) GHF0771 clips per lamp.
Item #: 56583 -
This is the classic beehive front indicator lamp, with amber glass lens and 2-wire bulb socket for single element bulb. As used on European and English spec from 1959 through 1985.
4/5/2018 12:00:00 AM
Item #: XBD100670 -
Front turn signal light for 1997-on MPi Rover Mini. Clear glass with amber bulb; includes new screws and base gasket.
8/31/2017 12:00:00 AM
Item #: 52338 -
Complete assembly with clear glass lens and chrome retaining ring, USA specification. Dual function (parking and indicator) socket. Sold each. For version with plastic lens, see 1B9100MS. Use 3
Item #: 13H2133 -
Fuel gauge for Minis 1964-1983 with center gauge cluster. These Minis were different than the earlier cars in that they were fitted with a voltage stabilizer, which gives a constant lower voltage to
Item #: 54382845 -
Replacement cover for the 4-fuse box, as used from 1976 through 2006.
Item #: 54380114 -
Plastic cover for original fuse box with two (2) fuses only.
6/5/2018 12:00:00 AM
Item #: 37420 -
Fuse box as used on most late Minis after 1976. Accepts four (4) fuses. With cover.
10/11/2017 12:00:00 AM
Item #: 54038068 -
Early style twin-fuse box as used on many Minis. This is the "later" early model with blade connectors. Comes with cover but no fuses. Order 188216 or 188216 fuses.
Item #: 188216 -
25 amp glass fuse. Sold each.
Item #: 188218 -
35 Amp glass fuse, for use in early Minis with two-fuse box. Sold each.
Item #: XFH100460 -
Foam gasket to fit tail lamp lenses with integral clear reverse lenses, except for Altissimo-made units. Fits both left and right sides, two (2) per car needed; sold each.
Item #: 37H6778 -
Foam rubber lens seating gasket as used on Mk2 tail lamp. Sold each.
Item #: 54571330 -
The Mk1 tail lamps use this sponge rubber gasket between the lamp base and the body. Fits both right and left sides.
Item #: 57H5167 -
The Mini Van, Estate (Wagon) and traveller (Woody) tail lamps use this sponge rubber gasket between the lamp base and the body. Fits both right and left sides.
Item #: 54570450 -
This sponge rubber gasket fits between the lens and the tail lamp assembly on the Mk1 Mini, both right and left sides.
Item #: SIB422 -
Smiths water temperature gauge; 30-110° Celsius with 6' capillary mechanical fittings.
Item #: 13H4460 -
Original spec electrical water temp gauge as used in Mk2-on Minis. Rounded chrome bezel replaces earlier v-shaped type. Smiths marking, with C-N-H scale. Normally used with GTR0104 sending unit.
Item #: 13H4460MG -
Electrical water temp gauge as used in Mk2 on Minis. As original, but with popular magnolia face. Rounded chrome bezel. Smiths marking, with C-N-H scale.
Item #: 12H0067-USED -
Flat metal bar is slotted so the generator can be moved in and out for belt adjustment. Available used only.
Item #: 2A0128 -
Mounts to the front engine plate to allow adjustment of the generator and belt.
Item #: USB104 -
Easy to change, the brushes for the C40-1 generator are sold in sets.
Item #: UTB100 -
Excessive belt tension can prematurely damage this bearing.
Item #: WKN0404 -
Small key to secure the pulley to the shaft of the generator.
Item #: UTB110 -
This bronze bushing is found at the rear of the Lucas C40-1 generator.
Item #: G-2014E -
Lucas Generator, rebuilt in the USA. Suitable for positive or negative ground Minis. These are genuine Lucas generators, not the made-in-India replacements. Price includes $40.00 refundable core charge. You
Item #: GXE3101 -
Brand-new aftermarket reproduction generator. To be used NEGATIVE GROUND only. Sold outright - no exchange necessary.
Item #: 5L0023 -
Large rubber grommet to fit 1" hole for passage of wires, hoses, pipes etc. The center hole is 7/32". Sold each.
Item #: 3F0090 -
Rubber grommet in boot lid to isolate the wires to the license plate lamp.