Electrical

Deluxe black wrinkle-finish steel mounting pod for 80mm tachometer. Adjustable swivel mount. Ref: TACH01, SEL0033.

Mounting pod for 80mm tachometer, in chrome. Ref: SEL0029, SIB801.

80mm genuine Smiths 8000 RPM tachometer with chrome bezel. Ref: SIB120, SIB120MG.

Dual-function tail and brake light for the Austin Mini Moke: red glass lens, socket with bulb, rubber boot and chrome retaining ring. Ref: 1B9101, 53564.

Rubber seal between lamp base and body on Mk2 classic Mini Saloons. Ref: 37H2689, 37H2690.

Left-hand side rubber gasket for lamp base-to-body on Mk4 and later classic Mini Saloons with reverse lights. Ref: 37H2691, 54590554.

Right-hand side rubber gasket for lamp base-to-body on Mk4 and later classic Mini Saloons with reverse lights. Ref: 37H2692, 54590555.

Restoration-quality reproduction of the tail light for the Mk2 or Mk2 classic Mini. Ref: 54674, 54675, 13H6479, 13H6480.

Brown plastic sensor for fan and ECU, fitted in sandwich plate below thermostat on twin-point classic Minis. Ref: GTR206, MEK100060, GTR313.

Temperature sending unit as fitted to SPi (single-point injection) classic Minis only from 1992 to 1996. Note large plastic end for wiring connection.

This sending unit for the temperature gauge was used starting in about 1970 when negative ground was introduced. Ref: GTR101, GTR0101, SNB103.

Temperature sending unit for classic minis with dual gauges, 1964 to 1969. Ref: GTR104, SNB102.

10-wire female connector plug for five (5) circuits. Used on the wiring harness to the steering column on Mk1 classic Mini and Mini Moke. Ref: 850832, CWB304.

Female connector plug to accept two bullet connectors. Ref: 900288, 2H3406, CWB300.

Female tube connector for joining four wires of a common circuit. Ref: 850641, 2H2617, CWB301.

Three-piece kit includes turn button, retaining clip and spacer to hold the large distributor water shield in place. Ref: 13H6461.

Front turn signal and parking lamp assembly as used on the classic Mini Moke and MG1100; amber and clear lens. Ref: 52572, LMP170, 13H0519, 13H519.

Front turn signal and parking lamp assembly for the classic Mini Moke and MG1100; clear lens. Ref: 52573.

Steering column switch for turn signal, headlamp high/low beams, flasher, and horn push for late Mk2 and Mk3 classic Minis to 1976. Ref: 39384, 13H7779, SQB168.

Round body signal flasher switch; controls the intermittent flashing of the turn indicator lamps of most classic Mini models 1969 to 1992.

Turn signal flasher switch, as typically found on early classic Minis; three (3) spade connections. Ref: GFU2103, SFB105, GFU103.

Switch fitted on classic Minis from about 1990 until 1996; controls horn, headlamp flash and turn signals. Ref: 35483, BAU5345, SQB115.

Multi-function turn signal switch for left-hand drive (LHD) classic Minis 1976 to 1989. Ref: 30445, 21A2660, SQB166.

Mk1 classic Minis featured this nifty turn signal switch with the green reminder blinker fitted in the end of the lever. Ref: 31945, 2A6215.

The correct turn signal switch for the Mk2 classic Mini; identical to the Mk3 switch, but the harness ends with male bullet connectors. Ref: 35840, 13H7778.

Steering column indicator (turn-signal) switch for MPi classic Minis starting in 1996. Ref: XPC100200PMP, SQB183.

Multi-function turn signal/horn/flasher switch for right-hand drive classic Minis from 1976-1989; right-hand mounting. Ref: 30443, 21A2658, SQB189.

Specially-converted starter for high-compression engines with pre-engaged starter and 129-tooth ring gear. Ref: GXE1005, FOR038.

Vacuum tube assembly that runs from the carb to vacuum advance unit on the distributor. Ref: 37H4229, 37H4229M.

Vacuum advance unit for the early 25D distributors; uses thumb-knob (not included) for fine-tuning of ignition timing. Ref: 54414868, 37H3840, 37H3840MS.

Vacuum advance unit for 45D and 59D distributor in 1275cc applications.

Vacuum advance module as Lucas 54425008. Fits the 59D4 distributor, such as 41857A as fitted to some 998 engines. Ref: 37H8414MS, 37H8381.

Flexible vacuum line connector that slips over the nipple on carburetor.

90° vacuum fitting, typically used on the carburetor-end of the vacuum advance tubing. Ref: 12B2062.

Straight vacuum fitting, typically used on the distributor-end of the vacuum advance tubing. Ref: 12B2095.

52mm diameter 10-15 volt meter, chrome bezel with SMITHS logo; choose black or magnolia face. Ref: SIB220, SIB220MG, ABV2220-00C, ABV2220-04C.

Also called the ''contol box'', this unit controls the output of the generator to keep the battery fully charged. Ref: NCB101, 37290, GEU6603.

Replacment control box for Austin America and MG1100 for original RB340 Lucas unit. Ref: NCB130, NCB130E, LUNCB130.

Voltage stabilizer for classic Mini Clubman models, and 1984-1988 classic Minis with driver’s-side gauge cluster.

A modern, solid-state version of the voltage stabilizer; for negative ground classic Minis only. Ref: C34770A, BR1310-00.

A modern, solid-state version of the voltage stabilizer; for positive ground classic Minis only. Ref: C34770, C34770POS, C34770-POS.

Windshield washer fluid bottle, as fitted in the engine compartment from 1983-88, and in the boot 1991-on. Ref: GWW935, ADU3906.

Washer bottle cap for wide mouth version of early washer reservoir GWW918. Ref: GWW952, RTC3880EVA.

Blue cap with lanyard for windscreen washer bottle GWW935, which was fitted either under the hood or in the boot. Ref: GWW975.

Cap and tubing outlet for GWW906 washer reservoir. Also fits the center of GWW952 cap. Ref: GWW951, DMB000951EVA.

All-in-one kit that includes a windshield washer fluid bottle, electric pump, and mounting bracket. Ref: WSB101.

One-liter water bottle as used from approximately 1970-1980. Ref: GWW906, 13H6482, WSB180.

White plastic windshield washer reservoir, as fitted in the engine compartment on 1988-91 classic Minis. Ref: GWW940.