Products 721-768 of 769
6/6/2017 12:00:00 AM
Item #: CZH0202 -
Concealed hinges were one of the improvements of the Mk3 Mini, and they are far less wear prone than the Mk1-2 type. Upper RH side.
Item #: 14A7167 -
Fits upper channel in the door on sliding window Mini. This flexible channel replaces the rigid upper one and is easier to install. Supplied in a roll, the channel presses
9/5/2017 12:00:00 AM
Item #: SBO0087 -
Inner rear valance for the classic Mini Van, Estate, and Pickup.
Item #: 12A1205 -
Rectangular sticker found on top of Austin engines.
Item #: SMI0137 -
Rectangular sticker found on top of British Leyland era engines.
Item #: SMI0111 -
Rectangular sticker found on valve cover of Morris engines.
Item #: SMI0145 -
Rectangular sticker found on top of many valve covers.
Item #: RFN0403 -
Rubber grommet to prevent chafe of the tank vent hose where it passes through the boot floor.
Item #: SMI0079 -
Correct VIN, or Chassis ID plate, for Austin Minis from 1959 through 1965. No seat belt reference.
Item #: SMI0158 -
Metal VIN body plate for Austin Morris Group. It is normally stamped from the back side with the car's VIN number in the open space.
1/8/2018 12:00:00 AM
Item #: SMI0081 -
Blank metal Austin VIN plate.
Item #: SMI0080 -
Blank metal VIN plate from "Morris Motors Ltd."
Item #: CP477 -
Chassis VIN plate for Rover Minis from approximately 1988-1999.
Item #: SIB220 -
52mm diameter Volt Meter, made by the original Manufacturer. Chrome bezel with black face with SMITHS logo.
Item #: SIB220MG -
52mm diameter Volt Meter, made by the original Manufacturer. Chrome bezel with magnolia face with SMITHS logo.
Item #: DFP100400 -
Special seal/seating strip used on Sportspack flare sets. Fits between the flare and the body. Sold per seal, use 4 per car. Genuine Rover.
Item #: PAM3077 -
The upper window seal is supplied in a premeasured roll. It is easily installed into the upper channel. Photo shows PAM3076.
Item #: PAM3076 -
The seal for the upper window channel is supplied in a roll of premeasured length. It is easily installed into the channel.
4/19/2018 12:00:00 AM
Item #: 14A7631 -
Rigid vertical dual channel for sealing rear side windows in Estate models. Fits forward location only.
4/24/2018 12:00:00 AM
Item #: 14A7630 -
Rigid dual channel vertical window glass seal for rear of side windows in Estate models.
Item #: 24A0948 -
Rubber channel (seal) to fit in metal door glass lift brackets. Four (4) Required per car.
Item #: CZH0701PA -
Black plastic collar between the handle and door panel upholstery. Sold each.
Item #: 14A7065 -
Round fiber washer fits under the chrome window lock boss on the outside of the glass.
Item #: 14A8151 -
Chrome button on the outside of the glass. Use with 14A7065 washer on the outside and 24A1198 gasket on the inside.
Item #: 24A1303/4 -
Chrome lower window channel for sliding window doors. This is drilled for engaging the window locks and for drainage into the door's metal channel.
Item #: MSSK015 -
Plastic window lock set for all 2-hole sliding windows as found on Mk1-Mk2 doors. Complete kit with all parts needed for installation.
Item #: RMP0307 -
Pozidrive screw to attach the window lock to the chrome boss.
Item #: 24A1198 -
This molded plastic seal sits under the window lock to prevent rattles and the entry of water. Fits all 4 window locks, sold each. See also MSSK015 complete
Item #: 24A2391-OE -
Fold-up chrome window lock for the sliding windows on the rear/side of the Mini and Clubman Estate. With plastic latch as original. Sold each.
Item #: 24A1195 -
Plastic window lock as used on Mk1 and Mk2 Minis. This type replaced the original chrome metal ones and fits the 2-hole glass. For left front glass. See MSSK015
Item #: 24A1194 -
Plastic window lock as used on Mk1 and Mk2 Minis. This type replaced the original chrome metal ones and fits the 2-hole glass. For right front glass. See MSSK015
Item #: 24A1197 -
Plastic window lock as used on Mk1 and Mk2 Minis. This type replaced the original chrome metal ones and fits the 2-hole glass. For left rear glass. See MSSK015
Item #: 24A1196 -
Plastic window lock as used on Mk1 and Mk2 Minis. This type replaced the original chrome metal ones and fits the 2-hole glass. For right rear glass. See MSSK015
Item #: 13H0525 -
The lower trim strip is held in place by clips which attach to the sheet metal below the window opening.
Item #: CZH0647 -
This is the internal door mechanism to raise and lower roll-up windows. Left-hand side.
Item #: CZH0646 -
This is the internal door mechanism to raise and lower roll-up windows. Right-hand side.
Item #: 13H0744 -
Clip with rivet that holds the stainless steel trim on the upper door frame on Mk1 and Mk2 Cooper S plus Riley Elf.
Item #: 13H0743 -
Round, button shaped clip with an integral rivet, fits in holes around the upper door window frame.
Item #: 13H0743-OE -
Clip used to hold the upper window chrome, except at the very bottoms of each leg, where three each of the 13H0744 are used.
Item #: SBO0731 -
Aftermarket windscreen cowl panel. Includes lower part of windscreen pillars. Punched for both right-hand drive (RHD) and left-hand drive (LHD) wiper hole locations.
8/21/2017 12:00:00 AM
Item #: HMP441001 -
This is the panel in front of the windscreen, and includes the lower sections of the windshield pillars. Drilled for both right-hand drive (RHD) and left-hand drive (LHD) wiper locations. Genuine Heritage.
Item #: CZH624-USED -
Windscreen defogger/defroster vent nozzle, to spread warm air across the window. Heater hoses attach to bottom, then nozzle is screwed into the underside of the upper dash.
Item #: SBO0028/9 -
Reproduction patch panel to repair the windscreen cowl and/or pillar base; choose right- or left-hand side.
Item #: JPC2017 -
Small metal chrome cover for windscreen seal filler strip insert.
Item #: SBO0027 -
Both front and rear windscreens on the Mini use a filler strip to expand and seat the seal. In chrome or black; order ten (10) feet for front screen, nine (9) feet for rear.
Item #: MYH5096 -
The rubber bottom seal piece for the classic Moke windshield.
Item #: CZH3140 -
If a serious accident such as a rollover has damaged the metal windshield panel, it can be replaced. Genuine Rover/Heritage.
Item #: STL0026 -
Pro quality rubber-handled tool for installing the filler strip in the front and rear windscreens. Includes adapters to fit many different cars. Made in England.