Products 1-46 of 46
Item #: ALA7306 -
Side cover plate for the classic Mini Moke battery box.
Item #: ALA7305 -
Weld-in rail that support the battery within the battery compartment. As the battery rests directly on these, they a very frequently rusted.
Item #: ALA9999 -
Weld-in battery support for the Mini Moke. Has threaded inserts to take the battery hold-down bar.
Item #: ALA7156 -
Oval-shaped metal panel that covers the the battery access panel on top of the classic Moke side pod.
Item #: SBO0265 -
Bonnet cloth braid to prevent metal-to-metal contact. Sold in one-meter lengths.
Item #: HYK2570 -
Rubber bonnet hook to secure the Moke hood. Fits snugly over the existing peg on the body and into the receiver on the hood. Sold each.
Item #: ALA7164 -
Metal panel that covers the side storage panels on the classic Mini Moke.
Item #: 24A0571 -
UK Moke toeboard-mounted dip switch wiring harness protector.
Item #: ALA7001 -
Very accurate UK-made reproduction of the original Moke front panel.
Item #: SIE0307 -
Replacement fiber and cork gasket for the Moke fuel tank cap; with paper masking.
Item #: ALA7328 -
Front grab handle for the classic Moke, fits right or left side. Sold each.
Item #: ALA7329 -
Rear grab handle for the classic Moke, fits right or left side. Sold each.
Item #: HYE0880 -
Removable grille panel as used on Australian and Portugese Mokes. Special order, lead time may be required.
Item #: AYK5786 -
Mini Moke hand brake cables for Australian model with 13" wheels. The longer rear radius arm requires longer hand brake cables.
Item #: BHM9665 -
The correct hand brake cables for UK and Australian Mokes with 10" wheels. They are longer than the cable used on Mini Van/Estate/Pickup due to the location of the hand brake lever.
Item #: 54570651 -
Clear lens with chrome ring for the front parking light and turn signal assembly, as used on the UK Mini Moke & MG1100 Sedan.
Item #: 576109 -
Red glass beehive lens only, as used on rear of Moke models.
Item #: ALA7189 -
Rear license plate mounting for some Moke models, including U.K. Metal.
Item #: 8G8710 -
This UK-made mirror head is heavily chrome plated and uses flat glass. This is also the mirror that mounts to the Moke's windshield frame. See also?M91422C for retaining nut, sold
Item #: SEVU0023-HORN -
Used inner and outer steering column assembly for Mk1 Mini and Moke. Cleaned, painted, and new bushings installed. In good condition.
Item #: HYK2675 -
Rubber finishing plug for the tubular bumper on early Mokes. Sold each.
Item #: ALA7322 -
This bolt-on access panel had to be made removable so that the fuel tank could be installed. It forms the rearmost portion of the floor under the left hand side panel.
Item #: ALA7076 -
A pair of half-floor panels suitable for the UK Moke. Complete front to rear, but do not include the center tunnel.
Item #: ALA7015 -
Left-hand inner weld-in hull section (bottom) with seat belt installation panel for the classic Mini Moke.
Item #: ALA7014 -
Right-hand inner weld-in hull section (bottom) with seat belt installation panel for the classic Mini Moke.
Item #: ALA7318 -
These are the weld-on panels that form the bottom of the Moke?s side pontoon boxes, and complete the floor.
Item #: ALA7320 -
Right-hand side panel for 10"-wheel Moke. Battery and storage compartment covers not included. Threaded inserts accept battery cover; drilled to accept 1/4 turn fasteners.
Item #: ALA7003 -
Lower portion of the Moke toe board, with reinforcement panels. A critical panel, because the front subframe bolts to it.
Item #: ALA9998 -
Metal bracket to anchor the top bows on the Mini Moke; welds to pannier top.
Item #: ACB9249 -
Mini Moke fuel pump mounting bracket, with mounting bolts.
Item #: 53837 -
License plate lamp for Mk1-2 Minis, Van, Traveller, Pick-Up, and Moke. On LWB (long wheel base cars) there are two, one on either side of the US license plate.
Item #: 502268G -
Rubber o-ring that goes around the outside of the chrome bezel on the large, center binnacle speedometers found on early Mini and Moke.
Item #: ALA7312/3 -
Inner reinforcement of the outside lower sill, often rusted and replaced when replacing outer sides and floor.
Item #: BMK353 -
Complete assembly for the red reflector used on the rear of the UK Moke. Includes reflector, chrome bezel, rubber base, and mounting screw.
Item #: 24A1444 -
Moke shift boot metal retainer ring.
Item #: SBO0266 -
Basic, thick rope-pattern mats, precut to fit the Moke's floors to help catch dirt and water. Set of four (4) pieces.
Item #: ALA7231 -
?T? shaped rubber seal that fits into the lower windshield frame and seals the gap to the body.
Item #: ALA7321 -
Left-hand side panel for 10"-wheel Moke. Storage compartment cover not included; drilled to accept 1/4-turn fasteners.
Item #: ALA7215 -
The Moke's spare tire is bolted to the rear panel with this special bolt and collar assembly.
Item #: 53564 -
Dual function tail and brake light for the Austin Mini Moke. Complete with red glass lens, socket with bulb, rubber boot and chrome retaining ring.
Item #: GWC0102 -
Genuine Lockheed or Unipart wheel cylinders from Seven. The twin leading shoe brakes used two wheel cylinders of different internal bore diameters. This must be checked before ordering. If you
Item #: MYH5096 -
The rubber bottom seal piece for the classic Moke windshield.
Item #: MYH5095 -
The rubber top seal piece for the classic Moke windshield.
Item #: 318ALT -
Complete wiring harness for the UK-made Austin Mini Moke, 1964-66 approximately. Made to original patterns with proper wire colors and fittings, but modified for used with alternator.
Item #: 318 -
Complete wiring harness for the UK-made Austin Mini Moke. Made to original patterns with proper wire colors and cloth wrapping. Special Order, lead time may be required.